What are the components of the bag making machine cutting system?
2022-07-15
The Bag Making Machine cutting system consists of cutter, length adjuster, overrunning clutch, welding wire adjustment and other parts. 1. Knife: It is the most important part of the system. It is a floating structure compressed by a spring and a movable knife and sliding guide, and the upper and lower knives can be adjusted. There are adjusting screws in the middle, which can be used to adjust the tightness of the cutter, and can well eliminate the phenomenon that the material is difficult to cut. 2. Bag-making length adjuster: The bag-making length is adjusted by changing the position of the connecting rod on the eccentric carriage to control the bag-making length, and adjusting the bag-making size by tightening the handwheel and the nut. 3. Overrunning clutch: Sinoplastic overrunning clutch is an important part of the machine. Its quality and performance directly affect the length of the product. However, during the use process, due to the high working frequency, its lifespan also has a certain limit. If it is found that there is an error in the length of the bag making during the production process (usually after half a year of continuous production), and if the other faults cannot be solved, the clutch can be disassembled for inspection and repair. 
4. Adjustment of the distance between the welding line and the cutting line: the distance between the welding line and the cutting line is generally 5-10mm. Roll the handwheel on the adjustment frame to make the beam roller rise or fall a certain distance to obtain the ideal cutting line. In order to facilitate the investigation of the quality of the welding wire, the welding wire orientation of the single bottom wire can be adjusted to the outer end of the machine cutter. If the welding line and the bottom line are not parallel, loosen the fixing screw of a bevel gear, and turn the handwheel to raise or lower one end of the beam roller; after the production is stable, lock the screw of the gear. 5. Welding knife adjustment method: put a piece of tissue paper on the support seat, roll the large handwheel in the box by hand to make the welding knife at the bottom dead center, loosen the nut and adjust the nut, and try to pull the ends of the tissue paper by hand. Press down until about equal. After adjustment, tighten the nut to prevent loosening. 6. Automatic light-controlled feeding equipment: This equipment is composed of servo motor, feeding rubber roller, light-controlled film shutter, curtain, photoelectric tracking machine and electric control line. Its function is to maintain normal film feeding during the production process. When the machine is running, when the film feeding speed is too fast to block the light control ray, the equipment will issue an instruction to make the motor stop rolling and feeding.Composite integrated bag making machine Okay, the above is the content of today's editor's sharing of "what are the components of the bag making machine cutting system", I hope it will be helpful to everyone.
